Differential mesowear in occluding upper and lower molars: opening mesowear analysis for lower molars and premolars in hypsodont horses.

A new approach of reconstructing ungulate diet, the mesowear method, was recently introduced by Fortelius and Solounias ([2000] Am Mus Novitat 3301:1-36). Mesowear is based on facet development on the occlusal surfaces of the teeth. Restricting mesowear investigation to maxillary cheek teeth would allow mesowear investigation only in assemblages of large numbers of individuals and therefore would generally restrict this method to relatively few assemblages of recent and fossil ungulates. Most of the fossil, subfossil, and recent ungulate osteological assemblages that may be assigned to a single taxon have smaller numbers of individuals. This results in a demand to extend the mesowear method to further tooth positions in order to obtain stable dietary classifications of fossil taxa. The focus of this article is to test if a consistent mesowear classification is obtainable for mandibular as well as for maxillary teeth. For statistical testing, large assemblages of isolated cheek teeth of the Vallesian hipparionine horse Hippotherium primigenium and of the recent zebra Equus burchelli were employed as models. The upper tooth positions P4, M1, M2, and M3 as suggested by Kaiser and Solounias (2003) as the model for the "extended" mesowear method and the lower tooth positions P4-M3 were tested for their consistency in classification of the mesowear variables. We found a considerable shift of the mesowear signature towards the grazing edge of the mesowear continuum in lower cheek teeth. In order to adjust the signal of lower teeth to the signal of the upper teeth, a calibration factor was introduced which allowed incorporation of lower cheek teeth into the same model of mesowear investigation together with upper cheek teeth. We propose that this model is particularly suited for the reconstruction of paleodiets in hypsodont hipparionine and equine equids. We further investigated the functional relation between the mesowear profiles and the distribution of dental tissues along the course of the occlusal contact. We therefore correlated mesowear profiles with enamel distribution profiles and found the mesowear profile to be strongly controlled by the attritional environment encountered by a given apex area. The differential signal observed in cusp apex morphology between upper and lower cheek teeth was found to be more closely related to attrition by the antagonistic tooth than to the distribution of dental tissues in the tooth under consideration. The results suggest a general extension of the mesowear method of paleodiet reconstruction and a basic scenario for the evolution of anisodont dentitions. Copyright 2003 Wiley-Liss, Inc.