Aliphatic hydrocarbons and polycyclic aromatic hydrocarbons (PAHs) in sediments collected from the 110 mile hole and along a transect from 58 degrees 58.32'N 1 degree 10.38'W to the inner Moray Firth, Scotland.

Sediments were collected from the 110 mile hole and along a transect from 58 degrees 58.32' N 1 degree 10.38' W to the UK National Marine Monitoring (NMMP) site in the inner Moray Firth, for determination of hydrocarbon concentration and composition. Total PAH concentrations (2- to 6-ring PAHs, parent and branched) were highest at NMMP site 95 and at the associated end of the transect in the inner Moray Firth. PAHs in this area were of predominately pyrolytic origin and could be attributed to urban and industrial activities. The majority of sediments collected in the middle section of the transect had low total PAH concentrations (< 100 ng g(-1) dry weight). The high proportion of naphthalenes and alkylated PAHs in this area suggested a predominately petrogenic input. The GC-FID aliphatic hydrocarbon profiles showed that the majority of sediments, including those in the inner Firth, had a limited petrogenic input. This was supported by the geochemical biomarker profiles, which contained triterpanes typical of Middle Eastern crude oil. Principal component analysis was used to investigate spatial trends in the PAH distributions and demonstrated that there were differences between areas. The NMMP site 95 and transect start and middle sediments were well separated. PCA further confirmed that sediments from the NMMP site 95, the 110 mile hole and the inner Moray Firth (south west) end of the transect contained PAHs from predominately pyrolytic sources, whereas sediments from the north east end (start) and the middle of the transect were typified by a greater petrogenic component.