Molecular weight characteristics of humic substances from different environments as determined by size exclusion chromatography and their statistical evaluation.

Recorded molecular weights (MWs) for humic substances (HS) range from a few hundred to millions of daltons. For purposes of defining HS as a specific class of chemical compounds, it is of particular importance to ascertain if this broad range of MWs can be attributed to actual variability in molecular properties or is simply an artifact of the analytical techniques used to characterize HS. The main objectives of this study were (1)to establish if a preferential range of MWs exists for HS and (2) to determine any consistent MW properties of HS. To reach the goal, we have undertaken an approach to measure under standardized conditions the MW characteristics of a large set of HS from different natural environments. Seventy-seven humic materials were isolated from freshwater, soil, peat, and coal, such that each possessed a different fractional composition: humic acid (HA), fulvic acid (FA), and a nonfractionated mixture of HA and FA (HF). Size exclusion chromatography (SEC) was used as the analytical technique to determine molecular weight characteristics. The MW distributions were characterized by number (Mn) and weight (Mw) average MW, and by polydispersity. The complete range of Mw values varied within 4.7-30.4 kDa. The maximum Mw values were observed for peat HF and soil HA, whereas the smallest weights were measured for river water HF. Maximum values of polydispersity (3.5-4.4) were seen for peat HF and soil HA, while much lower values (1.6-3.1) were found for all preparations isolated with XAD-resins. Statistical evaluation showed consistent Mw and Mn variations with the HS source, while polydispersity was mostly a function of the isolation procedure used. A conclusion was made that HS have a preferential range of MW values that could characterize them as a specific class of chemical compounds.