PURPOSE: To evaluate the bond strengths of two different types of resin bonding systems to coronal dentin and dentin of the pulp chamber floor. MATERIALS AND METHODS: 20 extracted human molars were sectioned into three regions; superficial coronal dentin, deep coronal dentin and floor of pulp chamber dentin. The dentin surface of each region was bonded with Single Bond or Clearfil Liner Bond 2V. A core build-up light-cured resin composite, Clearfil Photocore, was placed and light-cured for 40 seconds. After storage in 37 degrees C water for 24 hours, shear bond strengths were measured using a single plane shear test assembly at a crosshead speed of 2.0 mm/minute. Morphological changes of the conditioned dentin and hybrid layer formation were observed by SEM. RESULTS: For Single Bond, the bond strengths to superficial dentin were within anticipated bounds (23 MPa), whereas the bond strengths to deep dentin (15 MPa) and floor of pulp chamber dentin (13 MPa) were significantly lower (P < 0.05). For Clearfil Liner Bond 2V, higher bond strengths (approximately 30 MPa) were obtained for each region. The data were analyzed by one- and two-way ANOVA, and Fisher's PLSD (P < 0.05). The appearance of the conditioned dentin varied according to dentin region and conditioner. For Single Bond, thick hybrid layers (3-4 microm) were observed, while thin hybrid layers (less than 0.5 microm) were observed in Clearfil Liner Bond 2V for all regions.
PURPOSE: To evaluate the bond strengths of two different types of resin bonding systems to coronal dentin and dentin of the pulp chamber floor. MATERIALS AND METHODS: 20 extracted human molars were sectioned into three regions; superficial coronal dentin, deep coronal dentin and floor of pulp chamber dentin. The dentin surface of each region was bonded with Single Bond or Clearfil Liner Bond 2V. A core build-up light-cured resin composite, Clearfil Photocore, was placed and light-cured for 40 seconds. After storage in 37 degrees C water for 24 hours, shear bond strengths were measured using a single plane shear test assembly at a crosshead speed of 2.0 mm/minute. Morphological changes of the conditioned dentin and hybrid layer formation were observed by SEM. RESULTS: For Single Bond, the bond strengths to superficial dentin were within anticipated bounds (23 MPa), whereas the bond strengths to deep dentin (15 MPa) and floor of pulp chamber dentin (13 MPa) were significantly lower (P < 0.05). For Clearfil Liner Bond 2V, higher bond strengths (approximately 30 MPa) were obtained for each region. The data were analyzed by one- and two-way ANOVA, and Fisher's PLSD (P < 0.05). The appearance of the conditioned dentin varied according to dentin region and conditioner. For Single Bond, thick hybrid layers (3-4 microm) were observed, while thin hybrid layers (less than 0.5 microm) were observed in Clearfil Liner Bond 2V for all regions.