The influence of drug type on the release profiles from Surelease-coated pellets.

The release of metoclopramide hydrochloride (a water-soluble cationic drug) and diclofenac sodium (a sparingly soluble anionic drug) from pellets coated with ethylcellulose from an aqueous ethylcellulose dispersion (Surelease) at different coating loads was investigated. The release rates of each drug decreased as the coating load of Surelease increased. However, despite its lower water solubility, diclofenac sodium was released slightly faster than metoclopramide hydrochloride at equivalent coating loads. Changes in the release rates after curing were more pronounced for metoclopramide hydrochloride and the release rates of diclofenac sodium were lower than those of metoclopramide hydrochloride after curing. Differences between the release behaviour of the two drugs were probably due to an interaction between the cationic metoclopramide and the anionic ammonium oleate present in the Surelease. The slower release of metoclopramide hydrochloride may be due to an in situ formation of a poorly soluble complex of the drug and the ammonium oleate. This complex, because of its large molecular size, may diffuse more slowly through the film, causing a reduction in the release rate of metoclopramide hydrochloride. This interaction may also account for the differences in release characteristics of the drugs after curing. During curing the surfactant, due to its unstable nature in heat, may be converted to its constituent components. The interaction of drug with the surfactant was reduced as the residue of the ammonium oleate decreased during curing. However, a relatively low volume flow rate of air, and therefore, slower removal of ammonia in the modified side-vented Manesty Accela-cota 10 may also have affected the coating process of the pellets. Copyright 2002 Elsevier Science B.V.