Literature DB >> 12425655

Rheology and dynamic light scattering of silk fibroin solution extracted from the middle division of Bombyx mori silkworm.

Akie Ochi1, Khandker S Hossain, Jun Magoshi, Norio Nemoto.   

Abstract

Dynamic light scattering (DLS) and rheological measurements were performed on aqueous silk fibroin solutions extracted from the middle division of Bombyx mori silkworm over a wide range of polymer concentration C from 0.08 to 27.5 wt %. DLS results obtained in the dilute region of C less than 1 wt % are consistent with a model that an elementary unit is a large protein complex consisting of silk fibroin and P25 with a 6:1 molar ratio. Rheological measurements in the dilute C region reveal that those units (or clusters) with the hydrodynamic radius of about 100 nm form a network extending over the whole sample volume with small pseudoplateau modulus mainly by ionic bonding between COO(-) ions of the fibroin molecules and divalent metallic ions such as Ca(2+) or Mg(2+) ions present in the sample and also that, after a yield stress is reached, steady plastic flow is induced with viscosity much lower than the zero-shear viscosity estimated from creep and creep recovery measurements by 4-6 orders of magnitude. Angular frequency omega dependencies of the storage and the loss shear moduli, G'(omega) and G' '(omega), measured in the linear viscoelastic region, indicate that all solutions possess the pseudoplateau modulus in the low omega region and samples become highly viscoleastic for C greater, similar 4.2 wt %. Above C = 11.2 wt % another plateau appears at the high omega end accompanied by a distinct maximum of G' ' in the intermediate omega region. The relaxation motion with tau = 0.5 s corresponding to the maximum of G' ' is one of characteristic properties of the fibroin solutions in the high C region. Thermorheological behaviors of the solution with C = 27.5 wt % show that the network structure formed in the MM part of the silk gland is susceptible to temperature and a more stable homogeneous network is realized by raising the temperature up to T = 65 degrees C.

Entities:  

Mesh:

Substances:

Year:  2002        PMID: 12425655     DOI: 10.1021/bm020056g

Source DB:  PubMed          Journal:  Biomacromolecules        ISSN: 1525-7797            Impact factor:   6.988


  7 in total

1.  Silk-Its Mysteries, How It Is Made, and How It Is Used.

Authors:  Davoud Ebrahimi; Olena Tokareva; Nae Gyune Rim; Joyce Y Wong; David L Kaplan; Markus J Buehler
Journal:  ACS Biomater Sci Eng       Date:  2015-08-24

2.  Vortex-induced injectable silk fibroin hydrogels.

Authors:  Tuna Yucel; Peggy Cebe; David L Kaplan
Journal:  Biophys J       Date:  2009-10-07       Impact factor: 4.033

3.  Ca2+-induced self-assembly of Bombyx mori silk sericin into a nanofibrous network-like protein matrix for directing controlled nucleation of hydroxylapatite nano-needles.

Authors:  Mingying Yang; Guanshan Zhou; Yajun Shuai; Jie Wang; Liangjun Zhu; Chuanbin Mao
Journal:  J Mater Chem B       Date:  2015-03-28       Impact factor: 6.331

4.  The Rheology behind Stress-Induced Solidification in Native Silk Feedstocks.

Authors:  Peter R Laity; Chris Holland
Journal:  Int J Mol Sci       Date:  2016-10-29       Impact factor: 5.923

5.  Analysis of the pressure requirements for silk spinning reveals a pultrusion dominated process.

Authors:  James Sparkes; Chris Holland
Journal:  Nat Commun       Date:  2017-09-19       Impact factor: 14.919

6.  Phase Behaviour and Miscibility Studies of Collagen/Silk Fibroin Macromolecular System in Dilute Solutions and Solid State.

Authors:  Ima Ghaeli; Mariana A de Moraes; Marisa M Beppu; Katarzyna Lewandowska; Alina Sionkowska; Frederico Ferreira-da-Silva; Maria P Ferraz; Fernando J Monteiro
Journal:  Molecules       Date:  2017-08-18       Impact factor: 4.411

7.  Seeking Solvation: Exploring the Role of Protein Hydration in Silk Gelation.

Authors:  Peter R Laity; Chris Holland
Journal:  Molecules       Date:  2022-01-16       Impact factor: 4.411

  7 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.