Literature DB >> 12409759

Computer-assisted secondary reconstruction of unilateral posttraumatic orbital deformity.

Nils-Claudius Gellrich1, Alexander Schramm, Beat Hammer, Sergio Rojas, Daniel Cufi, Wolf Lagrèze, Rainer Schmelzeisen.   

Abstract

Until now, computer-assisted surgery has not been practiced as part of the surgical routine of posttraumatic orbital reconstruction. The purpose of this study was to investigate the use of a navigation system for computer-assisted preoperative planning with virtual reconstruction to obtain symmetry of the orbits and intraoperative control of virtual contours in comparison with the clinically achieved surgical results. A further objective of the computer-assisted orbital analysis was to use an ideal measurement for the two-dimensional and three-dimensional changes following orbital reconstruction and to check the equality of the postoperative values for the affected orbits in comparison with those of the unaffected sides. Patients with unilateral posttraumatic orbital defects (n = 18) underwent computer-assisted surgery and preoperative planning using a spiral computed tomography database. Surgical procedures were preplanned with virtual correction by mirroring an individually defined three-dimensional segment from the unaffected side onto the deformed side, creating an ideal unilateral reconstruction. These computer-models were intraoperatively used as virtual templates to navigate the preplanned contours and the globe projection using the Stryker-Leibinger navigation system. Individual noninvasive registration with an overall inaccuracy of approximately 1 mm was achieved by using a maxillary occlusal splint with four markers. The mirroring of the unaffected side allowed an ideal virtual reconstruction. A mean decrease in enlarged orbital volume of 4.0 (SD +/- 1.9) cm was achieved, as was a mean increase in the sagittal globe projection of 5.88 (SD +/- 2.98) mm. With a paired Student test, the decrease between the preoperative and postoperative differences of the affected and unaffected sides was proved significant for orbital volume, globe projection, and computed tomography-based Hertel scale changes (p < 0.01). In 15 of 18 cases, simultaneous malar bone advancement resulted primarily in an additional increase in orbital volume before intraorbital augmentation with calvarial split-bone grafts could be performed. Intraorbital bony augmentation included one (n = 1), two (n = 7), three (n = 8), and all four (n = 2) orbital walls. Computer-assisted preoperative planning enables the surgeon to predict reconstructive surgical steps before the operation. Highly vulnerable structures such as the optic nerve can be detected and avoided intraoperatively, and virtually preplanned bone graft positions and/or orbital frame contours can be checked. Computer-assisted preoperative planning and surgery thus advance the difficult surgical field of orbital reconstruction, particularly through a greater exploitation of radiologic information without additional radiation to the patient.

Entities:  

Mesh:

Year:  2002        PMID: 12409759     DOI: 10.1097/01.PRS.0000029807.35391.E5

Source DB:  PubMed          Journal:  Plast Reconstr Surg        ISSN: 0032-1052            Impact factor:   4.730


  51 in total

1.  Reconstruction of defects of maxillary sinus wall after removal of a huge odontogenic lesion using prebended 3D titanium-mesh and CAD/CAM technique.

Authors:  Marcus Stoetzer; Majeed Rana; Constantin von See; André M Eckardt; Nils-Claudius Gellrich
Journal:  Head Face Med       Date:  2011-11-09       Impact factor: 2.151

2.  [Computer assisted methods in reconstructive and function-preserving orbital surgery. New capabilities of computer assisted preoperative surgical planning (CAPP) and computer assisted surgery (CAS)].

Authors:  C Zizelmann; A Schramm; R Schön; G J Ridder; W Maier; J Schipper; N-C Gellrich
Journal:  HNO       Date:  2005-05       Impact factor: 1.284

3.  Navigational maxillofacial surgery using virtual models.

Authors:  B Hohlweg-Majert; Ralf Schön; Rainer Schmelzeisen; Nils-Claudius Gellrich; Alexander Schramm
Journal:  World J Surg       Date:  2005-12       Impact factor: 3.352

4.  [New developments in navigation technology].

Authors:  O Majdani; M Leinung; R Heermann
Journal:  HNO       Date:  2006-11       Impact factor: 1.284

5.  Three-dimensional quantification of mandibular asymmetry through cone-beam computerized tomography.

Authors:  Lucia H S Cevidanes; Abeer Alhadidi; Beatriz Paniagua; Martin Styner; John Ludlow; Andre Mol; Timothy Turvey; William R Proffit; Paul Emile Rossouw
Journal:  Oral Surg Oral Med Oral Pathol Oral Radiol Endod       Date:  2011-04-16

6.  Preformed titanium meshes: a new standard?

Authors:  Marc Christian Metzger; Ralf Schön; Rainer Schmelzeisen
Journal:  Skull Base       Date:  2007-07

7.  Simultaneous cutting of coupled tetrahedral and triangulated meshes and its application in orbital reconstruction.

Authors:  Marc Christian Metzger; Marc Gissler; Matthias Asal; Matthias Teschner
Journal:  Int J Comput Assist Radiol Surg       Date:  2009-06-04       Impact factor: 2.924

8.  [Objectivity of therapeutic results following skull base surgery using virtual model analysis].

Authors:  J Schipper; T Klenzner; A Berlis; W Maier; C Offergeld; A Schramm; N-C Gellrich
Journal:  HNO       Date:  2006-09       Impact factor: 1.284

9.  Use of a Three-Dimensional Model to Optimize a MEDPOR Implant for Delayed Reconstruction of a Suprastructure Maxillectomy Defect.

Authors:  Anthony Echo; Erik M Wolfswinkel; William Weathers; Aisha McKnight; Shayan Izaddoost
Journal:  Craniomaxillofac Trauma Reconstr       Date:  2013-09-26

10.  Late treatment of orbital fractures: a new analysis for surgical planning.

Authors:  M Pagnoni; M Marenco; V Ramieri; V Terenzi; D Bartoli; G Amodeo; A Mazzoli; G Iannetti
Journal:  Acta Otorhinolaryngol Ital       Date:  2014-12       Impact factor: 2.124

View more

北京卡尤迪生物科技股份有限公司 © 2022-2023.