In situ detection of potassium atoms in high-temperature coal-combustion systems using near-infrared-diode lasers.

Direct tunable diode laser absorption spectroscopy at 769.9 and 767.5 nm was used to measure potassium (K) atom concentrations in situ in the high temperature (up to 1650 K) flue gas of two different pulverized coal dust combustion systems (atmospheric or pressurized (12 bar)). Two laser types (Fabry-Pérot (FP) and vertical-cavity surface-emitting lasers (VCSEL)) were used for the spectrometer and characterized with respect to the magnitude and linearity of their static and dynamic wavelength tuning properties. The wide continuous current-induced tuning range of the VCSEL of 20 cm(-1) (compared to 1 cm(-1) for the FP) make this laser ideal for species monitoring in high pressure processes. Two VCSELs were time-multiplexed to realize the simultaneous detection of the potassium D1 and D2 lines. Several oxygen absorption lines in the A-band, which are in close spectral vicinity of the K lines, were detected simultaneously, showing the possibility of multi-species detection with one laser. Using the FP-DL for the atmospheric process and the VCSEL for the high pressure process, the pressure-dependent coefficients for spectral broadening as well as a shift of the K line in the flue gas were determined to be (0.18 +/- 0.01) and (-0.060 +/- 0.003) cm(-1) per atm (at 1540 K and 11.2 bar). The total width and shift of the D1 line (11.2 bar/1540 K) were 60 and -20 GHz, respectively. The K atom concentration was determined continuously for several days in both plants under various operation conditions. Typical concentrations in the atmospheric plant were around 2 microg m(-3) with a range of 50 ng m(-3)-30 microg m(-3). Averaging 100 scans for each concentration value, we achieved a time resolution of 1.7 s and a detection limit of 10 ng m(-3), which corresponds to a fractional absorption in the 10(-3)-10(-4) range. A strong anti-correlation with the oxygen concentration could be verified. At the 12 bar plant, the concentration was again typically around 2 microg m(-3) but K levels up to 60 microg m(-3) were observed. Here, a strong dependence of the K-signal on the type of fuel could be verified.