O A Peters1, K Schönenberger, A Laib. 1. Department of Preventive Dentistry, Cariology and Periodontology, ETH, University of Zurich, Zurich, Switzerland. peters@zmk.unizh.ch
Abstract
AIM: The aim of this study was to compare the effects of four preparation techniques on canal volume and surface area using three-dimensionally reconstructed root canals in extracted human maxillary molars. In addition, micro CT data was used to describe morphometric parameters related to the four preparation techniques. METHODOLOGY: A micro computed tomography scanner was used to analyse root canals in extracted maxillary molars. Specimens were scanned before and after canals were prepared using Ni-Ti - K-Files, Lightspeed instruments, ProFile.04 and GT rotary instruments. Differences in dentine volume removed, canal straightening, the proportion of unchanged area and canal transportation were calculated using specially developed software. RESULTS: Instrumentation of canals increased volume and surface area. Prepared canals were significantly more rounded, had greater diameters and were straighter than unprepared canals. However, all instrumentation techniques left 35% or more of the canals' surface area unchanged. Whilst there were significant differences between the three canal types investigated, very few differences were found with respect to instrument types. CONCLUSIONS: Within the limitations of the micro CT system, there were few differences between the four canal instrumentation techniques used. By contrast, a strong impact of variations of canal anatomy was demonstrated. Further studies with 3D-techniques are required to fully understand the biomechanical aspects of root canal preparation.
AIM: The aim of this study was to compare the effects of four preparation techniques on canal volume and surface area using three-dimensionally reconstructed root canals in extracted human maxillary molars. In addition, micro CT data was used to describe morphometric parameters related to the four preparation techniques. METHODOLOGY: A micro computed tomography scanner was used to analyse root canals in extracted maxillary molars. Specimens were scanned before and after canals were prepared using Ni-Ti - K-Files, Lightspeed instruments, ProFile.04 and GT rotary instruments. Differences in dentine volume removed, canal straightening, the proportion of unchanged area and canal transportation were calculated using specially developed software. RESULTS: Instrumentation of canals increased volume and surface area. Prepared canals were significantly more rounded, had greater diameters and were straighter than unprepared canals. However, all instrumentation techniques left 35% or more of the canals' surface area unchanged. Whilst there were significant differences between the three canal types investigated, very few differences were found with respect to instrument types. CONCLUSIONS: Within the limitations of the micro CT system, there were few differences between the four canal instrumentation techniques used. By contrast, a strong impact of variations of canal anatomy was demonstrated. Further studies with 3D-techniques are required to fully understand the biomechanical aspects of root canal preparation.
Authors: Mario Dioguardi; Giuseppe Troiano; Luigi Laino; Lucio Lo Russo; Giovanni Giannatempo; Floriana Lauritano; Marco Cicciù; Lorenzo Lo Muzio Journal: Int J Clin Exp Med Date: 2015-10-15