Thrombin functions during tissue factor-induced blood coagulation.

Tissue factor-induced blood coagulation was studied in 20 individuals, for varying periods of time during 54 months, in contact pathway-inhibited whole blood at 37 degrees C and evaluated in terms of the activation of various substrates. After quenching over time with inhibitors, the soluble phases were analyzed for thrombin-antithrombin III (TAT) complex formation, prothrombin fragments, platelet activation (osteonectin release), factor Va generation, fibrinopeptide (FP) A and FPB release, and factor XIII activation. TAT complex formation, for 35 experiments, showed an initiation phase (up to 4.6 +/- 0.6 minutes) in which thrombin was generated at an average rate of 0.93 +/- 0.3 nM/min catalyzed by about 1.3 pM prothrombinase yielding approximately 26 nM thrombin. During a subsequent propagation phase, thrombin was generated at a rate of 83.9 +/- 3.8 nM/min by about 120 pM prothrombinase, reaching ultimate levels of 851 +/- 53 nM. Clot time, determined subjectively, occurred at 4.7 +/- 0.2 minutes and correlated with the inception of the propagation phase. The thrombin concentrations associated with the transitions to rapid product formation are 510 +/- 180 pM for platelet activation (1.9 +/- 0.2 minutes), 840 +/- 280 pM for factor XIII activation and factor Va generation (2.2 +/- 0.6 minutes), 1.3 +/- 0.4 nM for FPA release (2.5 +/- 0.7 minutes), 1.7 +/- 0.5 nM for FPB release and prethrombin 2 (2.8 +/- 0.8 minutes), 7.0 +/- 2.2 nM for thrombin B chain (3.6 +/- 0.2 minutes), and 26 +/- 6.2 nM for the propagation phase of TAT formation (4.6 +/- 0.6 minutes). These results illustrate that the initial activation of thrombin substrates occurs during the initiation phase at less than 2 nM thrombin (0.2%). Most thrombin (96%) is formed well after clotting occurs.