Optimizing femoral component rotation in total knee arthroplasty.

Femoral component rotation is important in total knee arthroplasty to optimize patellofemoral and tibiofemoral kinematics. More recently, the epicondylar axis has been cited as the definitive landmark for femoral component rotation. However, there are few studies to support the validity of this rotational landmark and its effect on the patellofemoral and tibiofemoral articulations. In the current study, a total knee arthroplasty was done in 11 knees from cadavers. The knees were tested with various femoral component rotations from 5 degrees internal rotation to 5 degrees external rotation referenced to the epicondylar axis and to the posterior femoral condyles. Each knee acted as its own internal control. The knees were actively ranged from 0 degrees to 100 degrees by a force on the quadriceps tendon in an Oxford knee simulator. Three-dimensional kinematics of all three components were measured whereas a multiaxial transducer imbedded in the patella measured patellofemoral forces. Femoral component rotation parallel to the epicondylar axis resulted in the most normal patellar tracking and minimized patellofemoral shear forces early in flexion. This optimal rotation also minimized tibiofemoral wear motions. These beneficial effects of femoral rotation were less reproducibly related to the posterior condyles. Rotating the femoral component either internal or external to the epicondylar axis worsened knee function by increasing tibiofemoral wear motion and significantly worsening patellar tracking with increased shear forces early in flexion. Based on the current study, the femoral component should be rotationally aligned parallel to the epicondylar axis to avoid patellofemoral and tibiofemoral complications.