Structure and Thermodynamics of NaF-AlF(3) Melts with Addition of CaF(2) and MgF(2).

The NaF-AlF(3) system with additions of CaF(2) and MgF(2) has been studied with Raman and vapor pressure measurements for 3 >/= CR (NaF/AlF(3) molar ratio) >/= 1 and up to 50 mol % additive. The results show that the binary melt can be described using the two equilibria AlF(6)(3)(-) = AlF(6)(2)(-) + F(-) and AlF(5)(2)(-) = AlF(4)(-) + F(-) with equilibrium constants 0.25 and 0.05, respectively, at 1293 K. Both reactions have positive reaction enthalpies. The first equilibrium is strongly shifted to the right resulting in a melt mixture with very low AlF(6)(3)(-) concentrations even at the Na(3)AlF(6) composition. Evidence for nonideal mixing of anions was found. For the ternaries, models based on Raman data are presented and compared with vapor pressure measurements. Good agreement is observed when association between the additives, CaF(2) or MgF(2), with the AlF(5)(2)(-) ions in the melt was considered. This association could be experimentally observed through a band broadening and a slight shift in the AlF(5)(2)(-) band frequency. Our vapor pressures and Raman data both indicate that MgF(2) clearly acts as an acid when added to NaF-AlF(3) melts of any composition. When CaF(2) is added, a slight decrease of vapor pressure occurs. Raman data indicate a decrease of AlF(4)(-) concentration, corresponding to a dissociation of CaF(2) with liberation of F(-) ions. All these results are, however, very much dependent on the initial melt composition. These data are explained in terms of acid-base, dilution, and association reactions of the solute with the solvent.