[Nixtamalization cooking characteristics of 11 maize varieties].

In the present study, 11 maize varieties were analyzed for their nixtamalization cooking quality. The 11 varieties were grown in the same locality and in the same year. The samples were evaluated for their physical characteristics, such as moisture content averaging 13.3%, average 1000 kernel weight (312.5 g), grain hardness through density (1.28 g/ml) and percent floaters (9.5%). These data indicated that all maize varieties had a hard endosperm which is recommended for the nixtamalization cooking process. The 11 varieties were formed on the average by 5.7% seed coat, 11.5% germ and 82.8% endosperm. The low seed coat content suggest a low solids loss during processing. Cooking quality evaluation was done by applying a standard lime cooking procedure to all varieties. An average solid loss of 3.2% was measured, with 0.8% of seed coat still attached to the endosperm. Water absorption at the end of cooking was 40.8% without soaking and 46.9% at the end of soaking. Nixtamal moisture was 47.9% after soaking and only 41.5% at the end of cooking. Cooking time with soaking for 50% moisture in the grain varied from 69 to 122 minutes at 1500 meters over sea level. The cooked grain was dried with hot air and ground however, the particle size obtained was not as that in commercial nixtamalized maize flour. However, the cooking quality parameters to make dough and tortillas were acceptable, with a penetration index of hydrated flour of 178.6 mm, pH 7.97, water absorption index (WAI) of 3.23 g gel/g flour and 4.11% water solubility index (WSI). All flours from the 11 varieties of maize gave acceptable tortillas as evaluated by physical characteristics and sensory quality. However of the 11 varieties 7 including the control were superior for nixtamalization cooking quality.