Literature DB >> 11416850

In vitro biocompatibility study of electrically conductive polypyrrole-coated polyester fabrics.

Z Zhang1, R Roy, F J Dugré, D Tessier, L H Dao.   

Abstract

This study investigated the basic biocompatibility aspects of two types of polypyrrole (PPy)-coated polyester fabrics for possible use as vascular prostheses. These PPy-coated fabrics, PPy-Phos and PPy-Plas, were sterilized with ethylene oxide (EO) and the following characterizations were performed: surface morphology by scanning electron microscope, EO residuals analysis by the headspace method, acute systemic toxicity in the mouse model, hemolysis, blood coagulation time, viability and proliferation of endothelial cells measured with the WST-1 method, and activation of polymorphonuclear (PMN) cells indicated by the specific expression of interleukin 8 mRNA measured by reverse transcription polymerase chain reaction. Virgin polyester fabrics, expanded poly(tetrafluoroethylene) (ePTFE), and medical-grade Bionate 80A poly(carbonate urethane) were used as references in the cell culture experiments. The PPy-coated fabrics revealed different surface morphologies by showing more PPy lamina and clusters on the PPy-Plas. Neither of the PPy-coated fabrics had an adverse effect on hemolysis and coagulation time, and they did not cause any acute systemic toxicity. The EO residual level was as low as 5 ppm or less, which is considered quite acceptable. Although exhibiting a relatively low initial cell adhesion at 24 h, the two PPy-coated samples showed no cytotoxicity at 72 and 168 h. Bionate 80A and ePTFE recorded cytotoxicity at 72 and 168 h, respectively. The virgin fabrics also demonstrated a decrease of viable cells at 72 h that was not significant. The activation of PMN cells induced by both PPy-coated fabrics, the ePTFE, and the negative control was significantly lower than that induced by their respective tumor necrosis factor-alpha controls. These results therefore highlighted the potential of PPy-coated fabrics for use as cardiovascular prostheses. It was suggested that cell adhesion moieties should be incorporated into the PPy/fabric composite to increase cell adhesion and subsequent cell proliferation.

Entities:  

Mesh:

Substances:

Year:  2001        PMID: 11416850     DOI: 10.1002/1097-4636(200110)57:1<63::aid-jbm1142>3.0.co;2-l

Source DB:  PubMed          Journal:  J Biomed Mater Res        ISSN: 0021-9304


  10 in total

Review 1.  Biomaterials for Bone Regenerative Engineering.

Authors:  Xiaohua Yu; Xiaoyan Tang; Shalini V Gohil; Cato T Laurencin
Journal:  Adv Healthc Mater       Date:  2015-04-07       Impact factor: 9.933

Review 2.  Conducting Polymers for Tissue Engineering.

Authors:  Baolin Guo; Peter X Ma
Journal:  Biomacromolecules       Date:  2018-04-30       Impact factor: 6.988

3.  Effect of PEDOT:PSS in tissue engineering composite scaffold on improvement and maintenance of endothelial cell function.

Authors:  Masoumeh Hesam Mahmoudinezhad; Akbar Karkhaneh; Khosrow Jadidi
Journal:  J Biosci       Date:  2018-06       Impact factor: 1.826

4.  The Effect of Ca2+ and Mg2+ Ions Loaded at Degradable PLA Membranes on the Proliferation and Osteoinduction of MSCs.

Authors:  Sugoi Retegi-Carrión; Ana Ferrandez-Montero; Alvaro Eguiluz; Begoña Ferrari; Ander Abarrategi
Journal:  Polymers (Basel)       Date:  2022-06-15       Impact factor: 4.967

5.  Characterization of alkali-treated collagen gels prepared by different crosslinkers.

Authors:  Hirofumi Saito; Shun Murabayashi; Yoshinori Mitamura; Tetsushi Taguchi
Journal:  J Mater Sci Mater Med       Date:  2007-09-13       Impact factor: 3.896

6.  Tissue spinal cord response in rats after implants of polypyrrole and polyethylene glycol obtained by plasma.

Authors:  Roberto Olayo; Camilo Ríos; Hermelinda Salgado-Ceballos; Guillermo Jesus Cruz; Juan Morales; Maria Guadalupe Olayo; Mireya Alcaraz-Zubeldia; Ana Laura Alvarez; Rodrigo Mondragon; Axayacatl Morales; Araceli Diaz-Ruiz
Journal:  J Mater Sci Mater Med       Date:  2007-08-01       Impact factor: 3.896

7.  Polypyrrole-coated electrospun PLGA nanofibers for neural tissue applications.

Authors:  Jae Y Lee; Chris A Bashur; Aaron S Goldstein; Christine E Schmidt
Journal:  Biomaterials       Date:  2009-06-07       Impact factor: 12.479

8.  Haemocompatibility and ion exchange capability of nanocellulose polypyrrole membranes intended for blood purification.

Authors:  Natalia Ferraz; Daniel O Carlsson; Jaan Hong; Rolf Larsson; Bengt Fellström; Leif Nyholm; Maria Strømme; Albert Mihranyan
Journal:  J R Soc Interface       Date:  2012-02-01       Impact factor: 4.118

9.  Advances in Cell-Conductive Polymer Biointerfaces and Role of the Plasma Membrane.

Authors:  Anna Mariano; Claudia Lubrano; Ugo Bruno; Chiara Ausilio; Nikita Bhupesh Dinger; Francesca Santoro
Journal:  Chem Rev       Date:  2021-09-28       Impact factor: 60.622

10.  Recycled algae-based carbon materials as electroconductive 3D printed skeletal muscle tissue engineering scaffolds.

Authors:  Selva Bilge; Emre Ergene; Ebru Talak; Seyda Gokyer; Yusuf Osman Donar; Ali Sınağ; Pinar Yilgor Huri
Journal:  J Mater Sci Mater Med       Date:  2021-06-21       Impact factor: 3.896

  10 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.