Removal of easily biodegradable organic compounds by drinking water biofilms: analysis of kinetics and mass transfer.

This paper evaluates the rate of utilization of easily biodegradable organic compounds by drinking water biofilms. Tap water, which had been filtered through biologically active granular activated carbon, was used as an innoculum for biofilm growth in annular reactors (ARs). Synthetic cocktails of easily biodegradable material in the concentration range of 50-2,000 mgC/m3 were used as substrate for biofilm growth. Influent and effluent aggregate concentrations of biodegradable organic matter (BOM) were calculated by adding the measurable BOM components on a mass carbon basis. The aggregate BOM values were used for calculating the observed Damköhler number and Theile modulus (based on a reaction rate per unit surface area), which were used to determine whether external or internal mass transfer limited BOM removal. For all of the experimental trials, it was shown that neither external nor internal mass transfer limited BOM removal. Because the biofilms in this research are thin and the fact that mass transfer is not limiting, it was assumed that the bulk BOM concentration was approximately equal to the average BOM concentration in the biofilm. A linear model was obtained for the aggregate BOM flux and the product of the effluent BOM concentration and the biofilm density. The slope or the areal biodegradation rate (ka) for the aggregate BOM was 0.033 m/h, as determined through a linear regression.