Literature DB >> 11165109

The spray drying of acetazolamide as method to modify crystal properties and to improve compression behaviour.

P Di Martino1, M Scoppa, E Joiris, G F Palmieri, C Andres, Y Pourcelot, S Martelli.   

Abstract

Acetazolamide shows a very poor compression ability and tablets must usually be produced through a wet granulation process. However, the possibility to obtain pure acetazolamide for direct compression could be interesting for industrial application. With the scope to obtain a material for direct compression, three different crystallisation methods were chosen, with respect to acetazolamide solvent solubility. (a) Acetazolamide was dissolved in an ammonia solution and then spray dried. It was possible to characterise the spherical particles as a mixture of two polymorphic forms, I and II by Powder X-ray diffraction study. (b) Pure form I was obtained by slowly cooling to room temperature a boiling water solution. (c) Pure form II, the marketed form, was obtained by neutralisation of an ammonia solution. Their compression behaviour was investigated firstly by a rotary press. Whilst pure polymorphic forms I and II could not be compressed, the spray dried particles showed very good compression properties. In fact, tablets were obtained only by spray dried particles, which show very good properties under compression and the absence of capping tendency. On the other hand, it was impossible to obtain tablets from polymorphic forms I and II, whatever compression pressures were used. In order to explain their densification mechanism, a single-punch tablet machine, equipped for the measurement of the upper punch displacement in the die, was used. From calculated Heckel's parameters, it was demonstrated that the spray dried material shows a greater particle rearrangement in the initial stage of compression due to its spherical habit and minor wrinkledness of particle surface. The crystalline structure due to the presence of polymorphic forms I and II concur to lowering the intrinsic elasticity of the material. This fact avoids the risk of the rupturing the interpaticulate bonds, which are formed during the compression, concurring to the consolidation of the tablet.

Entities:  

Mesh:

Substances:

Year:  2001        PMID: 11165109     DOI: 10.1016/s0378-5173(00)00675-x

Source DB:  PubMed          Journal:  Int J Pharm        ISSN: 0378-5173            Impact factor:   5.875


  3 in total

Review 1.  Pharmaceutical particle engineering via spray drying.

Authors:  Reinhard Vehring
Journal:  Pharm Res       Date:  2007-11-28       Impact factor: 4.200

2.  Application of a four-fluid nozzle spray drier to prepare inhalable rifampicin-containing mannitol microparticles.

Authors:  Takuto Mizoe; Tetsuya Ozeki; Hiroaki Okada
Journal:  AAPS PharmSciTech       Date:  2008-06-18       Impact factor: 3.246

3.  Dissolution enhancement of chlorzoxazone using cogrinding technique.

Authors:  Mihir K Raval; Jaydeep M Patel; Rajesh K Parikh; Navin R Sheth
Journal:  Int J Pharm Investig       Date:  2015 Oct-Dec
  3 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.