T Kuroe1, H Itoh, A A Caputo, H Nakahara. 1. Division of Advanced Prosthodontics, Biomaterials Science, and Hospital Dentistry, UCLA School of Dentistry, USA.
Abstract
PURPOSE: The purpose was to determine, photoelastically, the locations of occlusal load-induced stress concentrations within a maxillary premolar as a function of degree of periodontal support. MATERIALS AND METHODS: Composite three-dimensional models of a maxillary first premolar were fabricated for quasi-three-dimensional photoelastic stress analysis. Individual materials were used to model enamel, dentin, periodontal ligament, and alveolar bone. Three levels of periodontal support reduction (0%, 20%, 25%) were simulated by varying the socket depth. Vertical loads of 10 lb were applied to: (1) tip of buccal cusp, (2) tip of lingual cusp, and (3) center of occlusal surface. The resulting stresses were monitored and recorded photographically in the field of a circular polariscope arrangement. RESULTS: Cuspal loading concentrated stress around the cervical region below the loaded cusp, being highest under buccal cusp loading. The location of the stress concentration shifted apically as periodontal support diminished. CLINICAL SIGNIFICANCE: Observed cervical stress concentration corresponded well to the common location of abfractions seen in clinical situations. Since the location of cervical stress concentration varied with occlusal conditions, occurrence of abfractions must be highly dependent upon each patient's occlusion. Periodontal support reduction shifted the location of highest stress away from the cementoenamel junction. Therefore, abfractions are less likely to occur on periodontally compromised teeth compared to stable teeth.
PURPOSE: The purpose was to determine, photoelastically, the locations of occlusal load-induced stress concentrations within a maxillary premolar as a function of degree of periodontal support. MATERIALS AND METHODS: Composite three-dimensional models of a maxillary first premolar were fabricated for quasi-three-dimensional photoelastic stress analysis. Individual materials were used to model enamel, dentin, periodontal ligament, and alveolar bone. Three levels of periodontal support reduction (0%, 20%, 25%) were simulated by varying the socket depth. Vertical loads of 10 lb were applied to: (1) tip of buccal cusp, (2) tip of lingual cusp, and (3) center of occlusal surface. The resulting stresses were monitored and recorded photographically in the field of a circular polariscope arrangement. RESULTS: Cuspal loading concentrated stress around the cervical region below the loaded cusp, being highest under buccal cusp loading. The location of the stress concentration shifted apically as periodontal support diminished. CLINICAL SIGNIFICANCE: Observed cervical stress concentration corresponded well to the common location of abfractions seen in clinical situations. Since the location of cervical stress concentration varied with occlusal conditions, occurrence of abfractions must be highly dependent upon each patient's occlusion. Periodontal support reduction shifted the location of highest stress away from the cementoenamel junction. Therefore, abfractions are less likely to occur on periodontally compromised teeth compared to stable teeth.