Phosphorylating pathways and fatigue development in contracting Xenopus single skeletal muscle fibers.

To investigate the differential contribution of oxidative and substrate-level phosphorylation to force production during repetitive, maximal tetanic contractions, single skeletal muscle fiber performance was examined under conditions of high-oxygen availability and anoxia. Tetanic force development (P) was measured in isolated, single type-1 muscle fibers (fast twitch; n = 6) dissected from Xenopus lumbrical muscle while being stimulated at increasing frequencies (0.25, 0.33, and 0.5 Hz), with each frequency lasting 2 min. Two separate work bouts were conducted, with the perfusate PO(2) being either 0 or 159 mmHg. No significant (P < 0. 05) difference was found in the initial peak tensions (P(0)) between the high (334 +/- 57 kPa) and the low (325 +/- 41 kPa) PO(2) treatment. No significant difference in P was observed between the treatments during the first 50 s. However, a significant difference in force production was observed between the high (P/P(0) = 0.96 +/- 0.02) and the low PO(2) condition (P/P(0) = 0.92 +/- 0.02) by 60 s of work. After 60 s, steady-state force production was maintained during the high compared with the low PO(2) condition until stimulation frequency was increased, at which point developed tension during the high PO(2) condition began to decline. Time to fatigue (P/P(0) = 0.3) was reached significantly sooner during the low (250 +/- 16 s) than the high PO(2) condition (367 +/- 28 s). These results demonstrate that during the first 50 s of 0.25-Hz contractions, substrate-level phosphorylation has the capacity to maintain force and ATP hydrolysis when oxidative phosphorylation is absent. This period was followed by an oxygen-dependent phase in which force generation was maintained during the high PO(2) condition (but not during the low PO(2) condition) until the onset of a final fatiguing phase, at which a calculated maximal rate of oxidative phosphorylation was reached.