Anterior surgery with short fusion using the Zielke procedure for thoracic scoliosis: focus on the correction of compensatory curves.

Anterior instrumentation is recommended to correct idiopathic thoracolumbar or lumbar scoliosis through short fusion within the major curve. Only a few reports exist of anterior surgical correction for thoracic scoliosis. This study assessed the results of Zielke instrumentation for thoracic curve and analyzed the three-dimensional correction of deformity, especially correction of the uninstrumented compensatory curve. Seventeen patients, who had undergone selective thoracic correction and fusion using the Zielke procedure to treat thoracic scoliosis, had been followed for at least 3 years. Three-dimensional correction was evaluated radiographically. Furthermore, three-dimensional back deformities were evaluated using a topographic body scanner. Twelve patients with a single thoracic curve and five with a double curve were all female, with a mean age of 14.6 years. The preoperative main thoracic curve was 54.8 degrees +/- 10.5 degrees (range, 40-78 degrees), and it was 23.8 degrees +/- 10.5 degrees (range, 7-40 degrees) at the final follow-up examination (p < 0.0001). The average correction rate of the main curves was 56.6%. By correcting the thoracic curve, the upper and lower compensatory curves were corrected spontaneously without surgical instrumentation, with average correction rates of 45.1% and 50.2%, respectively. The average correction loss of the main curve was 2.3 degrees. The hump angle measured using a topographic body scanner decreased from 12.8 degrees +/- 4.5 degrees to 8.4 degrees +/- 4.3 degrees after surgery (p = 0.0001). Of the three patients in whom the rod broke up, only one showed a correction loss of 10 degrees; however, bony fusion was obtained. Anterior short fusion for thoracic scoliosis appears to offer significant correction, stabilization, and spontaneous correction of the compensatory lumbar curve without limiting lumbar motion.