Oxygen mass transfer characteristics in a membrane-aerated biofilm reactor.

Immobilization of pollutant-degrading microorganisms on oxygen-permeable membranes provides a novel method of increasing the oxidation capacity of wastewater treatment bioreactors. Oxygen mass transfer characteristics during continuous-flow steady-state experiments were investigated for biofilms supported on tubular silicone membranes. An analysis of oxygen mass transport and reaction using an established mathematical model for dual-substrate limitation supported the experimental results reported. In thick biofilms, an active layer of biomass where both carbon substrate and oxygen are available was found to exist. The location of this active layer varies depending on the ratio of the carbon substrate loading rate to the intramembrane oxygen pressure. The thickness of a carbon-substrate-starved layer was found to greatly influence the mass transport of oxygen into the active biomass layer, which was located close to, but not in contact with, the biofilm-liquid interface. The experimental results demonstrated that oxygen uptake rates as high as 20 g m-2 d-1 bar-1 can be achieved, and the model predicts that, for an optimized biofilm thickness, oxygen uptake rates of more than 30 g m-2 d-1 bar-1 should be possible. This would allow membrane-aerated biofilm reactors to operate with much greater thicknesses of active biomass than can conventional biofilm reactors as well as offering the further advantage of close to 100% oxygen conversion efficiencies for the treatment of high-strength wastewaters. In the case of dual- substrate-limited biofilms, the potential to increase the oxygen flux does not necessarily increase the substrate (acetate) removal rate. Copyright 1999 John Wiley & Sons, Inc.