Literature DB >> 10064706

Characterization of distinct early assembly units of different intermediate filament proteins.

H Herrmann1, M Häner, M Brettel, N O Ku, U Aebi.   

Abstract

We have determined the mass-per-length (MPL) composition of distinct early assembly products of recombinant intermediate filament (IF) proteins from the four cytoplasmic sequence homology classes, and compared these values with those of the corresponding mature filaments. After two seconds under standard assembly conditions (i.e. 25 mM Tris-HCl (pH 7.5), 50 mM NaCl, 37 degrees C), vimentin, desmin and the neurofilament triplet protein NF-L aggregated into similar types of "unit-length filaments" (ULFs), whereas cytokeratins (CKs) 8/18 already yielded long IFs at this time point, so the ionic strength had to be reduced. The number of molecules per filament cross-section, as deduced from the MPL values, was lowest for CK8/18, i.e. 16 and 25 at two seconds compared to 16 and 21 at one hour. NF-L exhibited corresponding values of 26 and 30. Vimentin ULFs yielded a pronounced heterogeneity, with major peak values of 32 and 45 at two seconds and 30, 37 and 44 after one hour. Desmin formed filaments of distinctly higher mass with 47 molecules per cross-section, at two seconds and after one hour of assembly. This indicates that individual types of IF proteins generate filaments with distinctly different numbers of molecules per cross-section. Also, the observed significant reduction of apparent filament diameter of ULFs compared to the corresponding mature IFs is the result of a "conservative" radial compaction-type reorganization within the filament, as concluded from the fact that both the immature and mature filaments contain very similar numbers of subunits per cross-section. Moreover, the MPL composition of filaments is strikingly dependent on the assembly conditions employed. For example, vimentin fibers formed in 0.7 mM phosphate (pH 7.5), 2.5 mM MgCl2, yield a significantly increased number of molecules per cross-section (56 and 84) compared to assembly under standard conditions. Temperature also strongly influences assembly: above a certain threshold temperature "pathological" ULFs form that are arrested in this state, indicating that the system is forced into strong but unproductive interactions between subunits. Similar "dead-end" structures were obtained with vimentins mutated to introduce principal alterations in subdomains presumed to be of general structural importance, indicating that these sequence changes led to new modes of intermolecular interactions. Copyright 1999 Academic Press.

Entities:  

Mesh:

Substances:

Year:  1999        PMID: 10064706     DOI: 10.1006/jmbi.1999.2528

Source DB:  PubMed          Journal:  J Mol Biol        ISSN: 0022-2836            Impact factor:   5.469


  63 in total

1.  Coiled-coil trigger motifs in the 1B and 2B rod domain segments are required for the stability of keratin intermediate filaments.

Authors:  K C Wu; J T Bryan; M I Morasso; S I Jang; J H Lee; J M Yang; L N Marekov; D A Parry; P M Steinert
Journal:  Mol Biol Cell       Date:  2000-10       Impact factor: 4.138

2.  Conserved segments 1A and 2B of the intermediate filament dimer: their atomic structures and role in filament assembly.

Authors:  Sergei V Strelkov; Harald Herrmann; Norbert Geisler; Tatjana Wedig; Ralf Zimbelmann; Ueli Aebi; Peter Burkhard
Journal:  EMBO J       Date:  2002-03-15       Impact factor: 11.598

3.  Conserved disruptions in the predicted coiled-coil domains of eukaryotic SMC complexes: implications for structure and function.

Authors:  Matthew Beasley; Huiling Xu; William Warren; Michael McKay
Journal:  Genome Res       Date:  2002-08       Impact factor: 9.043

4.  Identification of novel principles of keratin filament network turnover in living cells.

Authors:  Reinhard Windoffer; Stefan Wöll; Pavel Strnad; Rudolf E Leube
Journal:  Mol Biol Cell       Date:  2004-03-05       Impact factor: 4.138

5.  The structure of vimentin linker 1 and rod 1B domains characterized by site-directed spin-labeling electron paramagnetic resonance (SDSL-EPR) and X-ray crystallography.

Authors:  Atya Aziz; John F Hess; Madhu S Budamagunta; John C Voss; Alexandre P Kuzin; Yuanpeng J Huang; Rong Xiao; Gaetano T Montelione; Paul G FitzGerald; John F Hunt
Journal:  J Biol Chem       Date:  2012-06-26       Impact factor: 5.157

6.  Microtubule-dependent transport of vimentin filament precursors is regulated by actin and by the concerted action of Rho- and p21-activated kinases.

Authors:  Amélie Robert; Harald Herrmann; Michael W Davidson; Vladimir I Gelfand
Journal:  FASEB J       Date:  2014-03-20       Impact factor: 5.191

7.  Assembly Kinetics of Vimentin Tetramers to Unit-Length Filaments: A Stopped-Flow Study.

Authors:  Norbert Mücke; Lara Kämmerer; Stefan Winheim; Robert Kirmse; Jan Krieger; Maria Mildenberger; Jochen Baßler; Ed Hurt; Wolfgang H Goldmann; Ueli Aebi; Katalin Toth; Jörg Langowski; Harald Herrmann
Journal:  Biophys J       Date:  2018-05-10       Impact factor: 4.033

8.  Structural Dynamics of the Vimentin Coiled-coil Contact Regions Involved in Filament Assembly as Revealed by Hydrogen-Deuterium Exchange.

Authors:  Aiswarya Premchandar; Norbert Mücke; Jarosław Poznański; Tatjana Wedig; Magdalena Kaus-Drobek; Harald Herrmann; Michał Dadlez
Journal:  J Biol Chem       Date:  2016-09-30       Impact factor: 5.157

Review 9.  Posttranslational modifications of desmin and their implication in biological processes and pathologies.

Authors:  Daniel L Winter; Denise Paulin; Mathias Mericskay; Zhenlin Li
Journal:  Histochem Cell Biol       Date:  2013-10-04       Impact factor: 4.304

10.  A crystal structure of coil 1B of vimentin in the filamentous form provides a model of a high-order assembly of a vimentin filament.

Authors:  Allan H Pang; Josiah M Obiero; Arkadiusz W Kulczyk; Vitaliy M Sviripa; Oleg V Tsodikov
Journal:  FEBS J       Date:  2018-06-25       Impact factor: 5.542

View more

北京卡尤迪生物科技股份有限公司 © 2022-2023.